docs
  • README
  • Browsing the Fides Innova ZKP Network
  • Connecting Your MetaMask to the Network
  • Full Node
  • Introduction
  • Mobile App
  • Publishing Service Contracts on the Fides Innova Blockchain
  • Web App (User Panel, Admin Panel)
  • Fides Zero-Knowledge Proof (ZKP) Algorithm
    • 1- Setup Phase
      • 1- Setup Phase
      • Example 1
      • Example 2
    • 2-commitment-phase
      • 2- Commitment Phase
      • Example 1
      • Example 2
    • 3- Proof Generation Phase
      • 3- Proof Generation Phase
      • Example 1
      • Example 2
    • 4- Proof Verification Phase
      • 4- Proof Verification Phase
      • Example 1
      • Example 2
    • 5-target-architecture
      • Target architecture - RISC-V RV32IM
      • Target architecture - ARMv6-M Cortex-M0 32-bit ARM - RaspberryPi Pico
      • Target architecture - Cortex-A53 - for Siemens SIMATIC IOT2050
  • Tech Stack
    • Message Queuing Telemetry Transport (MQTT) protocol
    • Service Contract
    • Service Market
    • ZKP-enabled JavaScript Execution
  • ZKP and IoT Device Firmware Integration (zk-Device Design)
    • E-Card; a sample zk-Device
      • Installation
      • Instruction Set Architecture (ISA)
      • Mesh IoT Network
      • Reset
Powered by GitBook
On this page
  1. ZKP and IoT Device Firmware Integration (zk-Device Design)
  2. E-Card; a sample zk-Device

Reset

PreviousMesh IoT Network

Last updated 7 months ago

Got it, let's make the adjustment:

Reset Instructions for the Sensor E-Card

To reset your sensor E-card, please follow these steps:

  1. Locate the Reset Push-Button and LED Indicator:

    • Identify the reset push-button and the LED indicator on your E-card. The reset push-button is typically a small, tactile button, and the LED is usually nearby.

  2. Initial Button Press:

    • Press and hold the reset push-button on the E-card.

    • Keep holding the button until you observe the LED on the E-card flashing rapidly. This indicates that the E-card is preparing for the reset process.

  3. Hold for 10 Seconds:

    • Once the LED starts flashing rapidly, continue to hold the push-button for an additional 10 seconds.

    • Do not release the button during this period, as doing so will interrupt the reset process.

  4. Release the Button:

    • After holding the push-button for 10 seconds, release it.

    • The LED may flash or change its pattern to indicate that the reset process is complete.

  5. Confirmation:

    • Wait a few moments for the E-card to complete its reset cycle.

    • The E-card should now be reset to its default settings. You may observe the LED returning to a steady state or another pattern indicating normal operation.

Notes:

  • Ensure that the E-card is powered on during the reset process.

  • If the reset does not seem to work, repeat the process carefully, ensuring each step is followed precisely.

By following these steps, your sensor E-card should be successfully reset.